Electrical engineering root cause analysis (RCA) related to poor power factor boosted as P.F was very low in an electrical substation.
| Article Type: | Root Cause Analysis (RCA) |
| Category: | Electrical |
| Equipment Type: | Motors |
| Author: | S. Raghava Chari |
Note: This root cause analysis (RCA) is from real-time scenarios that happened in industries during the tenure of two or three decades ago. These articles will help you to improve your troubleshooting skills and knowledge.
Poor Power Factor Problem
The power factor was low around 0.7 due to 50% loaded transformers feeding induction motors.
The State Electricity Board (SEB) threatened to discontinue the power supply of the PF if it is not raised to the statutory minimum 0.8
Solution & Benefits
Two capacitor banks installed on the 11-KV bus improved the power factor to > 0.9 and met the statutory requirements. About 10% less power bill is a bonus benefit.
Author: S. Raghava Chari
Do you face any similar issues? Share with us through the below comments section.
If you liked this article, then please subscribe to our YouTube Channel for Instrumentation, Electrical, PLC, and SCADA video tutorials.
You can also follow us on Facebook and Twitter to receive daily updates.
Read Next:
- Problems with Switchgear
- What is an Electrical Drive?
- Aluminum Cable Terminations
- What is a Magnetic Contactor?
- Arc Fault Breaker Problem Solved
