Example of 3-15 psi to 4-20mA Conversion

A current-to-pressure transducer is  used  to  convert  a 4-20 mA electronic  signal  into  a  3-15 PSI pneumatic signal.

This particular transducer is configured  for  reverse action instead  of direct, meaning that its pressure output at 4 mA should be 15 PSI  and its pressure  output  at 20 mA should be 3 PSI.

Calculate the necessary current signal value to produce  an output  pressure  of 12.7 PSI.

3-15 psi to 4-20mA Conversion

We are solving this problem using standard 4-20mA conversion Formula. Click here for formula

Reverse-acting  instruments  are  still  linear,  and  therefore  still  follow the slope-intercept  line formula y = mx + b, albeit with a negative slope:

Calculating and substituting the slope (m)  value for this equation, using the full rise-over-run  of the linear function.

Note how the “rise” is actually  a “fall” from 20 milliamps  down to 4 milliamps, yielding a negative value for m:

Therefore,  a current signal of 7.07 mA is necessary to drive the output of this reverse-acting I/P transducer to a pressure  of 12.7 PSI.

Articles You May Like :

PLC Analog Input Scaling

4-20mA Graphical Calculations

Formula for Current 4-20ma

PLC Raw Count Calculation

Transmitter PV Calculate