In this post, we will see the concept of a power transformer.
A transformer is an electrical device that is used to change voltage range; either increasing it to a certain level or decreasing it to a certain level. It is one of the most basic components used in an electrical network.
Voltage conversion is necessary because you cannot always apply the same input voltage to any device. Every instrument has its own set of power requirements and it varies from instrument to instrument.
Electrical power goes in three phases – generation, transmission, and distribution.
It has substations involved and the substation has many types of equipment; a transformer being one of them. One of the most commonly used types of transformer in it is a power transformer.
In this post, we will understand the concept of a power transformer.
The power transformer is used in the generation and transmission stages. It can be a single phase or three phases. A power transformer is used for stepping up or down higher rated voltages in both these stages.
Typically, it can step up from 11KV to around 800KV for transmission; and step down again from 800KV to 240KV or 11KV for aiding the distribution process. Its basic working is the same as the normal transformer that we know. Only there are some additional design changes in it for working at higher voltages.
This transformer is provided with tapping on the primary winding side. Power lines are subjected to many variations according to demands and to work with that, tapping is provided on the primary side. By setting the proper tap, we can maintain proper voltage at the secondary side winding. You can change the taps even when the power supply is on.
It is put in operation during peak load. This means, it is connected in parallel with a normal transformer and when there is high peak demand during morning or evening hours, then the power transformer is used.
During non-peak hours, the normal transformer comes into the picture and the power transformer is shut off. The main thing here is that power is transmitted without changing the frequency.
Two winding transformers are generally used where the ratio of high voltage and low voltage is greater than 2. It is cost-effective to use an auto transformer where the ratio between high voltage and low voltage is less than 2.
Power transformers are essential in minimizing substantial energy losses, due to Joule’s effect, in the transmission of large amounts of electrical power over long distances by converting it into high-voltage current and then stepping it down to a safer low-voltage current.
Power transformers are commonly found in power plants, industrial plants, and electric utility companies.
The components of a power transformer are mentioned below.
The power transformers are classified as follows.
In this way, we saw the concept of a power transformer.
The conveyor sorting machine is widely used in the packing industries using the PLC program…
Learn the example of flip-flop PLC program for lamps application using the ladder logic to…
In this article, you will learn the STAR DELTA programming using PLC controller to start…
Lube oil consoles of rotary equipment packages in industrial process plants are usually equipped with…
Rotating equipment packages such as pumps, compressors, turbines need the lube oil consoles for their…
This article explains how to blink lights in ladder logic with a detailed explanation video…
View Comments
Items missing from presentation : GRAPHICS ETC