Welcome to Electrical and Electronic Measurements & Instrumentation multiple choice questions and answers with explanation.
1. Resolution of an instruments is
A) ability to distinguish polarity.
B) the maximum quantity it can measure.
C) the minimum quantity it can measure.
D) the maximum non linearity.
2. The dynometer principle can be for
A) Voltmeter only.
B) Wattmeter only.
C) Ammeter only.
D) ammeter, voltmeter and wattmeter.
3. The resistance in the circuit of the moving coil of a dynamometer wattmeter should be
A) Low.
B) Very low.
C) High.
D) Almost zero.
4. In AC circuits, the connection of measuring instruments cause loading effect errors which may effect
A) only phase of the quantity being measured.
B) magnitude, phase and waveform of the quantity being measured.
C) none of the answers
D) only the magnitude of the quantity being measured.
5. The errors mainly caused by human mistakes are
A) observational error.
B) instrumental error.
C) gross error.
D) systematic error.
6. The measured value of a resistance is 10.25 ohm, whereas its value of 10.22 ohm.
What is absolute error of the measurement?
A) 15.36 ohm.
B) 0.03 ohm.
C) 0.01 ohm.
D) 10.26 ohm.
7. An analog ammeter is
A) an indicating instrument.
B) a recording instrument.
C) an absolute instrument.
D) a controlling instrument.
8. The scale of hot wire ammeter is
A) Cramped.
B) Non Linear.
C) Linear.
D) Absloute linear.
9. In measurement system, the function of the signal manipulating elements is to
A) change the magnitude of the input signal while retaining its identity.
B) to perform non liner operation like clipping filtering, chopping and clamping.
C) change the quantity under measurement to an analogues signal.
D) to perform linear operation like addition and multiplication.
10. The use of __________________ instruments is merely confined within laboratories as standardizing instrument.
A) indicating.
B) recording.
C) integrating.
D) absolute.
Click on the below button to launch the Quiz.
All 30 questions and answers are available in the Quiz.
Share your answers with us through the below comments section.
Take All Tests
In this article, we are going to discuss about shutter door control using induction motor…
Electrical Drives control the motion of electric motors. Motion control is required in industrial and…
PLC ladder logic design to control 3 motors with toggle switch and explain the program…
VFD simulator download: Master the online tool from the Yaskawa V1000 & programming software for…
The conveyor sorting machine is widely used in the packing industries using the PLC program…
Learn the example of flip-flop PLC program for lamps application using the ladder logic to…