Power Systems Objective Questions & Answers – Set 14

Example of base load stations are

Which of the following methods is/are used for reactive or voltage compensation

Which of the following is not base load power plant

The main objectives of power system is/are

Ferranti effect will not occur in which of the following transmission lines

If the percentage reactance of an element is 20 % and the full load current is 50 Amp, the short circuit current will be

Efficiency of thermal power plant can be taken as

Uses of diesel power stations

A 25 MVA, 11 kV alternator is supplying full load at a point of 0.75 lagging. Determine the percentage increase in earning capacity when it is operated at improved power factor of 0.96 lagging.

A diesel power station has fuel consumption of 0.28 Kg per kWh. The calorific value of fuel is being 10000 KCal / kg. Determine the overall efficiency

To improve the efficiency of thermal power plant ________________ is placed between boiler and turbine.

The only place where slip ring induction motors used in thermal power plants is

Operating time of pumped storage plant is

If the percentage reactance of an element is 20 % and the full load current is 50 Amp, the short circuit current will be

How to find the total number of strands (N) when number of layers (x) are given

Where do compounding done in thermal power plants

The amount of ash content in Indian coal

If the breakdown voltage of the insulator is high, the thickness of the insulator is

Advantages of per unit system is/are

Load frequency control is achieved by properly matching the individual machines

What will be the thermal efficiency of a 240 V, 1000 W electric kettle if it brings 2 liters of water at 15° C to boiling point 15 Minutes

Which cooling is preferred for large turbine generator

Most commonly used material for insulator is

A steam power generation has an overall efficiency of 20 %. 0.6 Kg of coal is burnt per kWh of electrical energy generated. Calculated the calorific value of fuel

In which power plant, the thermal efficiency is quite low

Sparse matrix is matrix which contain

In thermal power plants the size of coal after crushing

Mechanical energy is supplied to a DC generator at the rate of 4200 J / S. The generator delivers 32.2 Amp at 120 V. How much energy is cost per minute of operation

Reactance relays are used for the protection of

The time taken by the turbine to fall to 0 rpm speed from 3000 rpm is called