Bubbler Level Measurement Animation shows the working principle of bubbler level sensor.
Working Principle:
A fixed constant air supply will be given at the inlet (min 10psi). When there is no level in the tank then total air passed to atmosphere through pipe in the tank. When the level in tank increases means the proportional back pressure increases and the increased back pressure is proportional to level in tank.
When tank level is more then back pressure will increases. With the use a electronic transmitters (like pressure transmitters) we can convert the back pressure signal into 4-20mA level signal.
Learn an example PLC program to control a pump based on level sensors using ladder…
In the PLC timer application for security camera recording, when motion is detected then camera…
In this example, we will learn batch mixing with PLC ladder logic program using timer…
This PLC example on manufacturing line assembly is an intermediate-level PLC program prepared for the…
In this article, you will learn the PLC programming example with pushbutton and motor control…
This article teaches how to convert Boolean logic to PLC programming ladder logic with the…
View Comments
Hi Bharadwaj,
All the contents are really good and helps to refresh the principles. Additionally can you also add the applications and usage of specific measurements in field. Just an idea.
Eg: Magnetic Flow meters, Can be used only in Conductive fluids.
Sure, i will do my best. Also if any one interested to share their knowledge/data, plz send the information to instrumentationtools@gmail.com
Thanks
Sir, Parallely keep on posting related to PLC, DCS, MODBUS COMMUNICATION etc.
why are using Dp transmitter
Plz can any one tell how to calibrate LL pressure switch and HH pressure switch
awesome!! thanks for introducing the basics..
so kind of you
Great knowledge sharing..
Much needed..
Thank you very much..
Hello,
We have a wastewater pond, we installed two different level transmitters, guided wave radar, and bubble type radar, the depth of the pond is 3.8 Mtrs, but both transmitters are giving different readings, radar showing 57% while bubble showing 48% reading, is the working principle different for both transmitters? for example the bubble measure from the bottom while the radar reflects from the top of wastewater?