How to design a DC Power supply?
The first step of Power supply Design is Stepping Down the AC current into a lower voltage.
This is done by a Step Down Transformer.
Now we need to remove the Alternating Waves and make a DC Current from it.
For this purpose we will use a Bridge rectifier, in which the AC will be converted into DC.
Even if it is rectified, there will be some fluctuations in the output.
This can be removed by connecting a Capacitor Parallel, as it will not pass the DC and pass only the AC Current.
Thus the AC current will be bypassed through the Capacitor to the Ground and we will obtain a Direct Current signal at the output.
Now you can use this DC current for various applications.
In the image, the moving arrows shows that they are AC and constant arrows shows the DC.
Learn an example PLC program to control a pump based on level sensors using ladder…
In the PLC timer application for security camera recording, when motion is detected then camera…
In this example, we will learn batch mixing with PLC ladder logic program using timer…
This PLC example on manufacturing line assembly is an intermediate-level PLC program prepared for the…
In this article, you will learn the PLC programming example with pushbutton and motor control…
This article teaches how to convert Boolean logic to PLC programming ladder logic with the…
View Comments
Thanks Reddy sir u are giving so much knowledge .All student will always thankful to you always .Salute to you