Control valves are valves used to control conditions such as flow, pressure, temperature, and liquid level by fully or partially opening or closing in response to signals received from controllers...
To start up and shut down a three-phase AC induction motor, any three-pole switch with a suitable current rating will suffice. Simply closing such a switch to send three-phase power...
Tilting type level switch so designed to be hung in the tank with a stainless chain. When the switch inclines above 20 degrees owing to the increase of stored material,...
Load cell is a sensor or a transducer that converts a load or force acting on it into an electronic signal. This electronic signal can be a voltage change, current...
Sludge Level Probe uses an ultrasonic pulse to accurately measure the sludge level. An ultrasonic signal sent from the probe is directed towards the sludge blanket in the tank. Height...
Mass flow meters are the types of flow meters which are mainly employed in mass-related processes such as chemical reactions, heat transfer, etc. In all these processes, accurate measurement of...
Vortex Meters can be used for a wide range of fluids, i.e. liquids, gases and steam. They are to be seen as first choice, subject to verification to cover the...
Thermal mass flow meters employ the thermal dispersion principle whereby the rate of heat absorbed by a fluid flowing in a pipe or duct is directly proportional to its mass...
Oval gear meters are traditional, mechanical, positive displacement (PD) flow meters, first invented more than 50 years ago by OVAL Corporation of Japan and now widely used for flow metering...
This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. AcceptRead More